Fry Tub Inlet/Overflow kit

This is a kit to be used with a 1" bulkhead and 1" and 2" PVC pipe to create an overflow for a fry grow-out system. (Pipes can be SCH20 or SCH40). Consists of: An Inlet screen with 1.5-4.5mm holes that draws water from the bottom of the tub. A chain retaining ring to hold seahorse chains at the bottom, or a non-chain holding ring that prevents fry from getting under the inlet screen. A cap that reduces drain noise. A tangential inlet sprayer that helps create a swirl in the bucket. Not included, but needed: Muck Bucket, similar to the Tuff Stuff bucket ~ 15.5" of 1" PVC pipe ~13/5" of 2" PVC or ABS pipe  Bulkhead and outlet plumbing Inlet plumbing, that ends in a 1/2" PVC pipe for the inlet sprayer Mesh inlet screen for smaller fry   To install: Drill the bucket and install the 1" slip-thread or slip-slip bulkhead in the bottom, nut on the outside, gasket on the inside. Mount the bucket and plumb the drain as needed. Measure and cut the 1" PVC pipe to extend from the bulkhead (sli