Black on Neon Green Laserable ABS Sheet

These sheets have a plastic masking on the top side only. The back is not masked and may have minor scuffs and scratches. The cutting depth is 0.003". (0.005 Black cap, 0.055” clear middle, and 0.005 Radical Green) intended for backlighting) Instructions for Engraving and Cutting 2 color ABS sheets Please note these are intended as ‘a starting point’ and adjustments in 5% increments may be needed to achieve optimal results. Engrave Settings: @ 40 power / 90 speed / 400 DPI Cut @ 30 power / 15 speed / 1000 hz. Bottom Up Engraving: Change the orientation of your laser to begin engraving from the bottom of the material upwards. This simple process will minimize the amount of residue being exhausted over previously engraved material which can re-deposit on the warm core and make clean up difficult. You can change the orientation of your laser to bottom up engraving from the advanced tab in your print driver. PPI Settings: Lowering the number of pulse firings per inch, particularly when eng