FingerTech 'Viper' T-Spin UHMW Motor Guard
palmbeachbots.com

FingerTech 'Viper' T-Spin UHMW Motor Guard

$3.79
{{option.name}}: {{selected_options[option.position]}}
{{value_obj.value}}
Store Logo

Palm Beach Bots

View Store

Replacement UHMW Motor Guard for the Viper Tail Spinner Add-On. Is your Tail Spinner's armor getting a bit chewed up? Going to an event and needing spares? Grab a couple of these and you're good to go! Specification: Material: UHMW Polyethylene, 3.17mm (0.125in) thick Size: 87 x 31.75mm (3.43 x 1.25in) Weight: 7.5grams (0.26oz) Two holes plus two slots for mounting to a UHMW Tail Arm. Notes: Shipped flat. To bend: Clamp the UHMW Motor Guard 2cm (3/4”) from the end and bend it over 90 degrees. Repeat with the other side. The plastic will spring back and should then line up nicely with the shape of the UHMW Tail Arm. Secure the bent UHMW Motor Guard to the UHMW Tail Arm with four 4-40 x 3/8” Screws. Install the two middle screws first. The two side holes are slotted to make it easier to pull the sides tightly against the UHMW Tail Arm.

Show More Show Less