4-LED Harness - 1206 LEDs

The 4-LED harness is by far the easiest way to add 4 tiny superbright LEDs to your Tiny Whoop! Now in all colors and several beautiful combinations of colors!      With the ultra-light built in resistor, you can solder these 4 (1.2x0.6mm) LEDs to your whoop by connecting one positive and one negative wire directly to the (1S) main power (where your battery pigtail and your camera are soldered to the main board). Then it's just a matter of using some Welder glue to attach the LED to the frame. Directions below! I've also extented the wires a bit, so it's now possible to have all four LEDs on the farthest outside point on the duct, or anything else you can think of! The total weight of this harness is 0.41g It looks amazing in the air. not bad for 0.54 I've installed a TON of these LEDs and this is the easiest way to reliably install them:        I smear a tiny amount of Welder Glue on the back of the LED and a tiny amount on the frame or canopy where I want the LED to be. Then I wait a